Dhcp Clients List - TP-Link TL-WA7210N User Manual

TL-WA7210N
DHCP server on your AP. The default setting is Disable. If you disable the Server, you must
have another DHCP server within your network or else you must manually configure the
computer.
Start IP Address - This field specifies the first address in the IP Address pool. 192.168.0.100

is the default start IP address.
End IP Address - This field specifies the last address in the IP Address pool. 192.168.0.199

is the default end IP address.
Address Lease Time - Enter the amount of time for the PC to connect to the AP with its

current assigned dynamic IP address. The time is measured in minutes. After the time is up,
the PC will be automatically assigned a new dynamic IP address. The range of the time is 1 ~
2880 minutes. The default value is 120 minutes.
Default Gateway (optional) - Enter the IP address of the gateway for your LAN. The factory

default setting is 0.0.0.0.
Default Domain (optional) - Enter the domain name of the your DHCP server. You can

leave the field blank.
Primary DNS (optional) - Enter the DNS IP address provided by your ISP. Consult your ISP

if you don't know the DNS value. The factory default setting is 0.0.0.0.
Secondary DNS (optional) - Enter the IP address of another DNS server if your ISP

provides two DNS servers. The factory default setting is 0.0.0.0.
Click Save to save the changes.

Note:
To use the DHCP server function of the device, you should configure all computers in the LAN as
"Obtain an IP Address automatically" mode. This function will not take effect until the device
reboots.

4.8.2 DHCP Clients List

Selecting DHCP > DHCP Clients List will enable you to view the Client Name, MAC Address,
Assigned IP and Lease Time for each DHCP Client attached to the device (Figure 4-18).
ID - Here displays the index of the DHCP client.

Client Name - Here displays the name of the DHCP client.

MAC Address - Here displays the MAC address of the DHCP client.

Assigned IP - Here displays the IP address that the AP has allocated to the DHCP client.

Lease Time - Here displays the time of the DHCP client leased. Before the time is up, DHCP

client will request to renew the lease automatically.
You cannot change any of the values on this page. To update this page and to show the current
2.4GHz 150Mbps Outdoor Wireless Access Point User Guide
Figure 4-18 DHCP Clients List
55