Wireless Advanced - TP-Link TL-WA7210N User Manual

2.4ghz 150mbps outdoor wireless access point
Hide thumbs Also See for TL-WA7210N:
Table of Contents

Advertisement

TL-WA7210N
Note:
1) If you select the radio button Deny the stations specified by any enabled entries in the list
to access for Filtering Rules, the wireless station B will still not be able to access the router,
however, other wireless stations that are not in the list will be able to access the router.
2) If you enable the function and select the Allow the stations specified by any enabled
entries in the list to access for Filtering Rules, and there are not any enable entries in the
list, thus, no wireless stations can access the router.

5.7.4 Wireless Advanced

Selecting Wireless > Wireless Advanced will allow you to do some advanced settings for the
device in the following screen as shown in Figure 5-23. As the configuration for each operation
mode is almost the same, we take Access Point mode for example here.
Antenna Settings - The polarization of an antenna. You can select Vertical Antenna,
Horizontal Antenna or External Antenna.
Beacon Interval - The beacons are the packets sent by the Device to synchronize a wireless
network. Beacon Interval value determines the time interval of the beacons. You can specify
a value between 20-1000 milliseconds. The default value is 100.
RTS Threshold - Here you can specify the RTS (Request to Send) Threshold. If the packet
is larger than the specified RTS Threshold size, the Device will send RTS frames to a
particular receiving station and negotiate the sending of a data frame. The default value is
2346.
Fragmentation Threshold - This value is the maximum size determining whether packets
will be fragmented. Setting the Fragmentation Threshold too low may result in poor network
performance since excessive packets. 2346 is the default setting and is recommended.
DTIM Interval - This value determines the interval of the Delivery Traffic Indication Message
(DTIM). You can specify the value between 1-255 Beacon Intervals. The default value is 1,
which indicates the DTIM Interval is the same as Beacon Interval.
Enable WMM - WMM function can guarantee the packets with high-priority messages being
transmitted preferentially. It is strongly recommended enabled.
Enable Short GI - This function is recommended, for it will increase the data capacity by
reducing the guard interval time.
Enable AP Isolation - Isolate all connected wireless stations so that wireless stations cannot
access each other through WLAN. This function will be disabled if WDS/Bridge is enabled.
2.4GHz 150Mbps Outdoor Wireless Access Point User Guide
Figure 5-23 Wireless Advanced
91

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents