TP-Link TL-WA7210N User Manual page 37

TL-WA7210N
 VLAN ID - The ID of a VLAN. Only in the same VLAN can a Wireless PC and a wired PC
communicate with each other. The value can be between 1 and 4095. If the VLAN function is
enabled, when AP forwards packets, the packets out from the LAN port will be added with an
IEEE 802.1Q VLAN Tag, whose VLAN ID is just the ID of the VLAN where the sender
belongs.
Region - Select your region from the pull-down list. This field specifies the region where the

wireless function of the AP can be used. It may be illegal to use the wireless function of the AP
in a region other than one of those specified in this filed. If your country or region is not listed,
please contact your local government agency for assistance.
When you select your local region from the pull-down list, the Note Dialog of TERMS OF USE
will pop up. Select I agree to these terms of use, and click Accept to continue.

Note:
Ensure you select a correct country to comply with local laws. Incorrect settings may cause
interference.
 Transmission Power - The available options of transmission power are determined by the
region selected.
 Wireless Security Mode - You can select one of the following security options:
WPA/WPA2-PSK - Select WPA based on pre-shared passphrase.

No Security - The wireless security function is disabled. The wireless stations will

be able to connect the Device without encryption.
 Wireless Password - If the AP your Device is going to connect needs password, you need to
fill the password in this blank.
 Save - Save the current security configurations for the selected SSID.
2. The Network Setting page will appear then. It is recommended that you keep the default
settings on this page. Click Next.
2.4GHz 150Mbps Outdoor Wireless Access Point User Guide
Note Dialog
27