Table of Contents
Advertisement
3.4.2
Factory default setting
Figure 3.14 shows the default setting position at the factory. (Master device setting)
DC Power Connector
3.4.3
Jumper configuration
(1)
Device type
Master device (device #0) or slave device (device #1) is selected.
2
4
1
3
(a) Master device
Figure 3.15 Jumper setting of master or slave device
Note:
When the device type is set by the jumper on the device, the device should not be
configured for cable selection.
(2)
Cable Select (CSEL)
In Cable Select mode, the device can be configured either master device or slave device. For
use of Cable Select function, Unique interface cable is needed.
Figure 3.14 Factory default setting
6
8
2
4
5
7
9
1
3
(b) Slave device
C141-E072-01EN
Interface Connector
6
8
= shorted
5
7
9
3 - 13
Advertisement
Table of Contents
