Cable Connector Specifications; Device Connection; Power Supply Connector (Cn1); Cable Connections - Fujitsu MPD3XXXAH Product Manual

3.3.2

Cable connector specifications

Table 3.2 lists the recommended specifications for the cable connectors for Host system that
do not support Ultra DMA modes greater than mode 2.
For Host system that support Ultra DMA modes greater than mode 2, it is recommended to
use the 80-conductor cable assembly. The 80-conductor cable assembly is manufactured by
AMP or 3M.
ATA interface cable
(40-pin, CN1)
Power supply cable
(CN1)
Note :
The cable of twisted pairs and neighboring line separated individually is not allowed to use
for the host interface cable. It is because that the location of signal lines in these cables is
not fixed, and so the problem on the crosstalk among signal lines may occur.
It is recommended to use the ribbon cable for ATA interface that cable length is less than
18 inch (46 cm) and cable capacitance is less than 35 pico farad. Also it is recommended
to use AWG18 power supply cable.
3.3.3

Device connection

Figure 3.8 shows how to connect the devices.
ATA interface cable
Host system
3 - 8
Table 3.2

Cable connector specifications

Name
Cable socket
(closed-end type)
Cable socket
(through-end type)
Cable socket housing
Contact
Disk Drive #0
Disk Drive #1
Figure 3.8

Cable connections

C141-E072-01EN
Model
FCN-707B040-AU/B
FCN-707B040-AU/O
1-480424-0
60617-4
Power supply cable
DC
power supply
Manufacturer
Fujitsu
Fujitsu
AMP
AMP