Table of Contents
Advertisement
If your replacement hard drive does not have the bracket rails attached, remove the
5
rails from the old drive by removing the two screws that secure each rail to the drive.
Attach the bracket rails to the new drive by aligning the screw holes on the drive with
the screw holes on the bracket rails and then inserting and tightening all four screws
(two screws on each rail).
Install the hard drive into the computer by gently sliding the drive into place until you
6
hear it click securely.
98
Re m ov i n g a n d I ns t al l i n g Pa r t s
drive
bracket rails (2)
screws (4)
Advertisement
Table of Contents
