Table of Contents
Advertisement
Microprocessor
CAUTION: Before you perform this procedure, follow the safety instructions on
page 13.
Installing the Microprocessor
NOTE: It is recommended that only a technically knowledgeable person perform this procedure.
CAUTION: The processor can get very hot during normal operation. Ensure that
the processor has had sufficient time to cool before you touch it.
Follow the instructions in "Before You Begin" on page 80.
1
Open the computer cover (see page 82).
2
Remove the microprocessor airflow shroud (see page 105).
3
If you are replacing a microprocessor, follow steps 4, 5, and 6 in "Removing the
Microprocessor" on page 109.
NOTICE: You must position the microprocessor correctly in the socket to avoid permanent
damage to the microprocessor and the computer.
If the release lever is not extended to the release position, move it to that position.
4
Align pin-1 (the imprinted corner) of the microprocessor and pin-1 of the socket.
5
NOTICE: Microprocessor pins are delicate. To avoid damage, ensure that the microprocessor
aligns properly with the socket, and do not use excessive force when you install the processor.
Carefully set the microprocessor in the socket and press it down lightly to seat it.
6
Rotate the release lever back toward the system board until it snaps into place,
7
securing the microprocessor.
Rem ov i ng a n d I n s t a l l i n g Par t s
107
Advertisement
Table of Contents
