Table of Contents
Advertisement
If you are removing the card permanently, install a filler bracket in the empty card-slot
6
opening.
If you need a filler bracket, contact Dell (see page 129).
NOTE: You must install filler brackets over empty card-slot openings to maintain FCC
certification of the computer. The brackets also keep dust and dirt out of your computer.
Lower the retention arm and press it into place, securing the card(s) in the computer.
7
Close the computer cover (see page 117).
8
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then
plug it into the computer.
Connect your computer and devices to electrical outlets, and then turn them on.
9
Remove the card's driver from the operating system.
10
AGP Cards
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions on page 13.
Your Dell™ computer provides a connector for an AGP card.
Removing an AGP Card
Follow the instructions in "Before You Begin" on page 80.
1
Open the computer cover (see page 82).
2
Press the lever on the card retention arm and raise the retention arm.
3
Rem ov i ng a n d I n s t a l l i n g Par t s
93
Advertisement
Table of Contents
