Table of Contents
Advertisement
Connect the new drive to the set of rails that are attached to the inside of the cover. If
4
a set of rails is not attached inside the computer cover, contact Dell (see page 129).
If you are installing a replacement drive and the new drive does not have the bracket
5
rails attached, remove the rails from the old drive by removing the two screws that
secure each rail to the drive. Attach the bracket to the new drive by aligning the screw
holes on the drive with the screw holes on the bracket rails and then inserting and
tightening all four screws (two screws on each rail). See the diagram on page 98).
Gently slide the drive into place until the tabs securely click into position.
6
Connect the power and CD/DVD drive cables to the drive.
7
If you are adding a drive that has an audio cable, connect the audio cable to the audio
connector on the audio card.
104
Re m ov i n g a n d I ns t al l i n g Pa r t s
audio cable*
* Some drives do not
have this cable.
power cable
tabs (2)
CD/DVD drive cable
CD/DVD drive
Advertisement
Table of Contents
