Dell Active Fabric Manager Deployment Manual page 93

Partial Link
Table 24. Undiscovered Switch Error
Undiscovered Switch Error
Table 25. Discovered Switch Error
Discovered Switch Error
Disconnected
Switch Name Mismatch
a. Navigate to the Network >
b. From the Deploy Fabric pull-down menu, select the Deploy and Validate
option.
c. Click the Validation tab and then select the switches to validate.
d. Click the Deploy Selected link.
1. Verify that the switch is wired according to the wiring plan.
2. Verify the connectivity on the AFM from both of switches of the link.
3. Validate the switch.
a. Navigate to the Network >
b. From the Deploy Fabric pull-down menu, select the Deploy and Validate
option.
c. Click the Validation tab and then select the switches to validate.
d. Click the Deploy Selected link.
Recommended Action:
1. Verify that the switch has a valid IP address.
2. If required, correct the pre-deployment configuration.
3. From the AFM server, verify that the connectivity to the switch exists.
4. Verify that the switch is running the minimum required software.
5. Validate the switch.
a. Navigate to the Network >
b. From the Deploy Fabric pull-down menu, select the Deploy and Validate
option.
c. Click the Validation tab and then select the switches to validate.
d. Click the Deploy Selected link.
Recommended Action
1. Verify that the connectivity to the switch exists from the AFM server.
2. Verify that the switch is running the minimum required software.
3. Validate the switch.
a. Navigate to the Network >
b. From the Deploy Fabric pull-down menu, select the Deploy and Validate
option.
c. Click the Validation tab and then select the switches to validate.
d. Click the Deploy Selected link.
1. Verify that the IP address to switch name mapping is correct in the pre-
deployment configuration.
Fabric Name > Configure and Deploy.
Fabric Name > Configure and Deploy.
Fabric Name > Configure and Deploy.
Fabric Name > Configure and Deploy screen.
93