System3 Master Equalizer; System4 Master Tuning; System5 Local Control; System6 Metronome Output - Yamaha DTX Drums DTX502 Owner's Manual

Advanced Techniques
Setting Parameters using Menu Mode
Master Equalizer
System3
>System3 MEQ
"Lo=+ 2 Hi=+ 2 ‚
q Lo
The drum module features a two-band shelving equalizer as
its master EQ. Use this parameter to set the equalizer's low-
end gain in dB. The higher the value, the more the low end
will be boosted.
Settings 0 to +12
w Hi
Use this parameter to set the master equalizer's high-end gain
in dB. The higher the value, the more the high end will be
boosted.
Settings
0 to +12
Master Tuning
System4
>System4 Mtune
" tune=+
q Tune
Use this parameter to set the tuning for songs in steps of one
cent.
Settings
-100 to +100
NOTE
The above parameter has no effect on drum kit sounds.
Local Control
System5
>System5
"LocalCtrl=on
q LocalCtrl
Use this parameter to enable ("on") or disable ("off") playing
of the internal tone generator using the pads and songs. When
set to "off", the tone generator is essentially disconnected
from the pads and controllers, which will be unable to gener-
ate any sound.
Settings
off or on
74
DTX502 Owner's Manual
q w
0 ‚
q
‚
q
Metronome Output
System6
>System6 Click
"OutSel=mix
q OutSel
Use this parameter to specify where metronome sounds are to
be output.
Settings Description
The metronome is routed to the OUTPUT [L/
mix
MONO] and [R] jacks.
The metronome is routed to the OUTPUT [L/
MONO] jack only; drum and song sounds
clickL
are output in mono via the OUTPUT [R]
jack.
The metronome is routed to the OUTPUT
[R] jack only; drum and song sounds are
clickR
output in mono via the OUTPUT [L/MONO]
jack.
NOTE
The above setting also applies to output from the [PHONES]
jack.
Number Display Function
System7
>System7 LED
" Disp=tempo
q Disp
Use this parameter to specify what is to be shown by the
number display.
Settings Description
tempo Current tempo
Mode-specific content as follows.
• Kit area: Kit number
• Training Mode: Current tempo
• Song area: Song number
• Recording: Current tempo
mode
• Metronome area: Click Set number
(current tempo on Tap Tempo page
only)
• Menu Mode: No display (trigger setup
number in Trigger area only)
• All other times: No display
Metronome timer. Training timer when in
timer
Training Mode.
NOTE
In cases where the above parameter is not set to "tempo", the
number display will show the tempo for several seconds after it is
changed by one of the following actions.
• Turning the Data Dial with the [SHIFT] button held down
• Operating a pad controller whose function has been set to
"tempo" (page 62)
• Striking a pad whose pad function has been set to "inc
tempo", "dec tempo", or "tap tempo" (page 66)
‚
q
‚
q