Kitc3 Reverb Type; Kitc4 Reverb Return; Kitc5 Pad Control; Kitc6 Snare Adjustment - Yamaha DTX Drums DTX502 Owner's Manual

Advanced Techniques
Setting Parameters using Menu Mode
Reverb Type
KitC3
>KitC3
"ReVtype=hall1 ‚
q RevType
Use this parameter to select the type of reverb to be applied.
none, hall1, hall2, hall3, room1, room2,
Settings
room3, stage1, stage2, plate
Reverb Return
KitC4
>KitC4
"ReVMastRet= 64‚
q RevMastRet
Use this parameter to set the reverb unit's return level.
Settings 0 to 127
NOTE
The reverb return level can be adjusted to balance the volumes
of the sounds with reverb applied and those without.
62
DTX502 Owner's Manual
q
q
Pad Control
KitC5
>KitC5
"PacCtl=snares ‚
q PadCtl
When a pad unit equipped with a pad controller is connected
to the [qSNARE] jack, this parameter can be used to select a
function for the controller.
Settings Description
off Pad controller performs no function.
Adjustment of snare-wire tension (also affect-
snares
ing open-rim sounds)
Adjustment of tuning (also affecting open-rim
tuning
sounds)
tempo Adjustment of the tempo
Snare Adjustment
KitC6
>KitC6
" Snares= 4
q Snares
Use this parameter to adjust the snare-wire tension for the pad
connected to the [qSNARE] jack. An "off" setting simulates
the snare wires being fully removed from the head.
Settings Description
off Snare wires fully removed
Higher values correspond to tighter snare
1 to 24
wires and vice-versa.
Tempo
KitC7
>KitC7
" tempo=off
q Tempo
Use this parameter to specify the tempo to be set automati-
cally upon selection of the current drum kit. When set to
"off", the tempo will not change automatically when the cur-
rent kit is selected.
Settings
off, 30 to 300
q
‚
q
‚
q