Master Equalizer; First Page: Master Equalizer Gain; Second To Sixth Pages: Detailed Settings For Each Band - Yamaha CP1 Owner's Manual

Master Equalizer

The Master Equalizer block is used to adjust the overall tone of the entire Performance. Specifically, it can boost or cut
the signal level in the vicinity of a center frequency in five individual frequency bands. The Master Equalizer screen
extends over six individual pages.

First page: Master Equalizer gain

Press and hold the [MASTER EQUALIZER] button (for at least one second)  Press the [
Editing Sequence:
 Turn Knobs 2 to 6
Low
LowMid
Mid
HighMid
High

Second to sixth pages: Detailed settings for each band

Press and hold the [MASTER EQUALIZER] button (for at least one second)  Navigate to the desired page
Editing Sequence:
using the [
The second to sixth pages of the Master Equalizer screen are used to set parameters such as center frequency and gain
for each of five equalization bands. More specifically, the Low band is configured on the second page; the LowMid band,
on the third page; the Mid band, on the fourth page; the HighMid band, on the fifth page, and the High band, on the sixth
page. The parameters that can be set on these pages are as follows.
Shape
Gain
Freq (Frequency)
These parameters are used to specify the degree to which signal levels in the vicinity of the center
frequency of the corresponding band (Low, LowMid, Mid, HighMid, or High) are boosted or cut.
Setting values: -12 to +12 (dB)
] buttons  Turn Knobs 3 to 6
PAGE] and [PAGE
This parameter is used to specify whether shelving or peaking equalization is to be applied within the two
end bands — namely, Low and High. Accordingly, it is displayed only on the second (Low) and sixth (High)
pages.
Setting values: shelv (Shelving type) or peak (Peaking type)
shelv .............Signals at all frequencies either above (High band) or below (Low band) the specified
frequency will be boosted or cut.
EQ Low
+
0
–
peak .............Signals at frequencies around the specified center frequency will be boosted or cut.
This parameter is used to specify how much signal levels in the vicinity of the frequency set using the Freq
parameter will be boosted or cut.
Setting values: -12 to +12 (dB)
This parameter is used to set the central frequency around which levels will be cut or boosted.
Setting values:
Low band .....If Shape is set to "shelv": 32Hz to 2.0kHz
If Shape is set to "peak": 63Hz to 2.0kHz
LowMid, Mid, and HighMid bands....... 100Hz to 10.0kHz
High band ............................................ 500Hz to 16.0kHz
EQ High
Gain
+
Frequency
0
–
Frequency Frequency
+ Gain
Frequency
0
Frequency
–
Master Equalizer
PAGE] button
Gain
Frequency
55
CP1 Owner's Manual