01: Mixer Area: Mixer Settings; Mixer Mixer Settings; 02: Kitvoice Area: Settings Affecting Individual Voices; Kitv1 Layers - Yamaha DTX Drums DTX502 Owner's Manual

01: Mixer Area
Mixer settings
The Mixer area is used to adjust the volumes of the various drum
kit voices.
Mixer settings
MIXER
>MIXER
" Kick=16 HSKtCR
q Volume
Use the volume parameters to balance the input group* vol-
umes.
 Input group indicators
H: Hi-hat sound volumes
S: Snare sound volumes
K: Kick sound volumes
T: Tom sound volumes
C: Cymbal sound volumes
R: Degree to which reverb is applied
Use the [<]/[>] buttons to select an input group, and then
turn the Data Dial to adjust its volume. Faders are displayed
above each of the input-group indicators to give a general
idea of the current volume balance. The reverb (R) setting
applies to all of the drum kit's voices.
NOTE
*: Input groups
Voices are organized into input groups based on their voice
category. For example, when you change the T setting (tom
sound volumes), the volume of all sounds from the Tom (T)
voice category will change accordingly.
Settings
0 to 16
q
ÏÏÏÏÏÈ
Setting Parameters using Menu Mode
02: KitVoice Area
Settings affecting individual voices
The KitVoice area is used to set drum voices for individual trigger
input sources.
Layers
KitV1
>KitV1 snareHd
"Layer=stack
q Trigger input source
This item indicates the trigger input source currently selected
for editing. Trigger input sources can be selected by striking
the corresponding pad or zone. This selection applies to both
Layer A and Layer B. (Trigger input sources are not dis-
played individually for each layer.)
NOTE
You can also select trigger input sources by holding down the
[SHIFT] button and pressing the [<]/[>] buttons.
snareHd, snareOp, snareCl, snrOfHd,
snrOfOp, snrOfCl, tom1Hd, tom2Hd, tom3Hd,
rideBw, rideEg, rideCp, crashBw, crashEg,
crashCp, kick, pad8, hhOpBw, hhOpEg,
hhOpCp, hhClBw, hhClEg, hhClCp, hhFtCl,
Settings
hhSplsh, pad10, pad11, pad12, and kick2
For details on the correspondence between
trigger input jacks and trigger input sources,
refer to page 29.
Advanced Techniques
q
‚
w
DTX502 Owner's Manual
57