Kitc8 Trigger Setup Link; Kitc9 Midi Program Change; Kitc10 Midi Control Change - Yamaha DTX Drums DTX502 Owner's Manual

Trigger Setup Link
KitC8
>KitC8
"trgSetupLk=off‚
q TrgSetupLk
Use this parameter to assign a trigger setup to the currently
selected kit. Select "off" if the kit does not need a specific
trigger setup.
Settings
off, 01 to 30
MIDI Program Change
KitC9
>KitC9
"PC001 M000L000‚
e
On the MIDI Program Change page, you can specify the MIDI
Program Change number to be sent when the current kit is
selected, in addition to the corresponding Bank Select MSB and
LSB messages.
NOTE
By sending MIDI Program Change messages, you can have the MIDI
instrument automatically change its voice when you select the cur-
rent kit.
q MIDI channel (Ch)
Use this parameter to set the MIDI channel on which to send
the Program Change messages.
Settings
1 to 16
w Program-change output switch
Use this parameter to turn the output of Program Change
messages on or off.
Settings off or on
e Program change number
Use this parameter to set the Program Change number to be
sent.
Settings
001 to 128
r Bank Select MSB
t Bank Select LSB
Settings
000 to 127
NOTE
In order to set the Bank Select MSB and LSB parameters cor-
rectly, you will need to refer to the MIDI instrument's Voice List
and MIDI Data Format.
q
q w
Ch1=off
r t
Setting Parameters using Menu Mode
MIDI Control Change
KitC10
>KitC10
"Vol=100 Pan= C
e
On the MIDI Control Change page, you can set values for MIDI
Control Change volume and pan messages to be sent when the
current kit is selected.
NOTE
By sending these MIDI Control Change messages, you can have the
MIDI instrument connected via the MIDI OUT connector automati-
cally set its volume and stereo panning when you select the current
kit.
q MIDI channel (Ch)
Use this parameter to set the MIDI channel on which to send
the Control Change messages.
Settings
1 to 16
w Control Change output switch
Use this parameter to turn the output of Control Change mes-
sages on or off.
Settings
off or on
e Volume
Use this parameter to set a value for the Control Change vol-
ume message.
Settings 0 to 127
r Pan
Use this parameter to set a value for the Control Change pan
message.
Settings
L64 to C to R63
Advanced Techniques
q w
Ch1=off
r
DTX502 Owner's Manual
63