Canon imageCLASS MF7280 Sending Manual page 312

No response from the server. Check the settings.
Cause
Remedy
There are too many subdirectories.
Cause
Remedy
No response.
Cause 1
Remedy
Cause 2
Remedy
Cause 3
Remedy
Check the TCP/IP.
Cause
11
Remedy
Cannot find the selected server. Check the settings.
Cause
Remedy 1 Check the DNS Server Settings in TCP/IP Settings in Network Settings in
Remedy 2 Check whether the DNS server's DNS settings are correct.
11-6
Error Messages
The specified server settings are incorrect, or the server is not turned ON.
Alternatively, the machine's TCP/IP resources may be low.
Wait for a while, and then try browsing again. If there is still no response from
the server, try selecting another server.
You have exceeded the maximum number of subdirectory levels allowed.
Specify a different destination because the directory level that you are trying to
access cannot be specified.
The server was not running when you tried to send.
Make sure that the server is ON, and check the destination.
The network connection was lost when you tried to send. (Either you could not
connect to the destination, or the connection was lost before the job could be
completed.)
Check the status of the network.
A TCP/IP error occurred when you tried to send an e-mail message or an I-fax.
Check that the network cables and connectors are properly connected.
The machine's TCP/IP connection is not operating.
Check the IP Address Settings (IP Address, DHCP, RARP, BOOTP) in TCP/IP
Settings in Network Settings in System Settings (from the Additional Functions
screen). (See Chapter 3, "Using a TCP/IP Network," in the Network Guide.)
The IP address that the machine should connect to cannot be determined.
System Settings (from the Additional Functions screen). (See Chapter 3, "Using
a TCP/IP Network," in the Network Guide.)