Error Messages; Self-Diagnostic Display - Canon imageCLASS MF7280 Sending Manual

Error Messages

This section explains the various messages that appear on the touch panel display,
along with possible causes and remedies.
For explanations of messages that are not listed here, see the Reference Guide
and Network Guide.

Self-Diagnostic Display

Perform the necessary procedures according to the displayed self-diagnostic error
message.
Self-diagnostic error messages appear on the touch panel display at the following
times:
When scanning or printing cannot be performed because of an operational error
•
When you need to make a decision or take some action during scanning or
•
printing
When you need to make a decision or take some action while browsing the
•
network
The following is a list of self-diagnostic error messages, along with their possible
causes and remedies.
Out of resources. Wait for a moment, then perform operation again.
Cause You cannot browse the network. There is a lack of TCP/IP resources because
documents have just been continuously sent or are being continuously sent via
FTP or Windows (SMB).
Remedy Wait for a while, and then try browsing again.
Set the IP Address.
Cause This machine is not set with an IP address.
Remedy Specify the IP Address Settings in TCP/IP Settings in Network Settings in
System Settings (from the Additional Functions screen), turn the machine's
main power OFF, and then back ON. (See Chapter 3, "Using a TCP/IP
Network," in the Network Guide.)
11-5

Error Messages

11