Sharp FO-1660M Operation Manual page 86

Chapter 9 Optional Settings
Setting 12: OFF HOOK HOLD TIME
This setting can be used to make the fax automatically take over the line a set
number of seconds after an answering machine connected to the fax answers.
Set the number of seconds by entering a 3-digit number ("001" to "255"), or
enter "000" to turn off the function. (See Chapter 7 for more details.)
Initial setting: "000"
Setting 13: SELECT AUTO RECEIVE
Press "1" to have the fax answer a call if an answering machine connected to
the fax does not answer within 5 rings. Press "2" to turn the function off. (See
Chapter 7 for more details.)
Initial setting: "2"
Setting 14: PBX RECALL
This sets the recall mode used for transferring calls on a PBX or utilising BT
Network services. Refer to your PBX manual or consult your supplier for the
correct setting if the factory setting is inappropriate. Enter "1" for earth recall,
"2" for time break recall, or "3" for no operation.
Initial setting: "2"
Setting 15: FAX SIGNAL RECEIVE
Your fax is set to automatically begin reception if you hear a high-pitched fax
tone after answering a call. If you use a computer fax modem on the same line,
you must turn this setting off in order to prevent your fax from mistakenly
attempting to receive documents sent from the computer fax modem. Press "1"
to turn the setting on, or "2" to turn it off.
Initial setting: "1"
Setting 16: JUNK FAX NUMBER CHECK
Press "1" to prevent reception from fax numbers entered in the Anti Junk Fax
List. Press "2" to allow reception from all numbers.
Initial setting: "2"
Setting 17: POLLING
Press "1" if you want to use Rapid Key 15/POLL as a polling key. Press "2" if
you want to use it as a regular Rapid Key.
Initial setting: "2"
76