Table of Contents
Advertisement
Pressing the Boil Mode (L) switch overrides the programmed setpoint and the cookpot temperature
rises to boiling at 212°F (100°C). When the unit is in boil mode, boiL appears in both LED
displays. The unit remains in boil mode until the Simmer Mode switch is pressed or the unit is
turned off.
Pressing the Simmer Mode (R) switch causes the cookpot temperature to be maintained at the
programmed setpoint. If the cookpot temperature is above the setpoint,
LED widows. If the cookpot temperature is below the setpoint,
- - - -
(
) are displayed if the temperature is within 11°F (6°C) of setpoint.
1
5
1
LED Displays
2
Power Switches
3
Temperature Check/Program Lock
4
Program Mode Switch
P
FBKR18 S
ROGRAMMING THE
It is recommended that the simmer setpoint and the heat/stir times for all 10
products be programmed before the unit is first used in a rethermalizing cycle.
The simmer setpoint and product rethermalizing times are programmed at the factory. These are
test settings not default settings. You must program the unit for your own particular products.
Program the setpoint and all product rethermalizing times as follows:
1. Turn the computer on by pressing the Power
2. Enter the programming mode by pressing the Program Mode
left display. Press the switch again to exit the programming mode.
2
3
6
4
FBKR18 Series Computer
5
6
7
8
C
ERIES
OMPUTER
CAUTION
switch.
3-4
°
-HI is displayed in both
°
-Lo is displayed. Four dashes
2
7
Boil Mode Switch
Product Buttons 1 through 5
Product Buttons 6 through 10
Simmer Mode Switch
switch. CodE appears in the
1
8
Advertisement
Table of Contents
Troubleshooting
