Programming The Fbcr18 Series Computer; Operating The Fbcr18 Series Rethermalizer; Using The Fbcr18 Chill Feature - Frymaster Gas Rethermalizers FBKR18 Series Installation & Operation Manual

P FBCR18 S
ROGRAMMING THE
1. Turn the computer on by pressing the Power
2. Press the Program Mode
product buttons 1, 6, 5, and 10. (Press switch again to exit the programming mode.)
NOTE 1: The programming mode is not available while the computer is rethermalizing; the
display will flash BUSY.
NOTE 2: To toggle between Fahrenheit and Celsius temperature display, press the Program
Mode switch, then enter the code 1 6 5 8 by pressing the corresponding product buttons.
Next, press the Temperature Check/Program Lock
3. SP- is displayed in the left window and the setpoint in the right. Use the product buttons to
change the temperature up to 205°F (96°C). For example, pressing 1, 9, and 5 programs the
setpoint for 195°. When the correct setpoint is displayed, press the Program Mode
4. SELP (Select Product) appears in the display and the LEDs in the product buttons blink. Press
any of the product buttons to select it for programming.
5. PULL appears in the display. Press the product buttons to enter the desired heating time in
minutes and seconds. Press the Program Mode
6. SELP again appears in the display. To program the heating time for another product, press the
product button to be associated with it and repeat Step 5.
7. Press the Program Lock
O FBCR18 S
PERATING THE
1. Press the Power
upper water level sensor.
2. CYCL appears in the display and the unit enters a burner on/off cycle until the water in the
cookpot reaches 180°F (82°C). At that time, the display changes to -Lo- and the burners fire
continuously. When the water in the cookpot is within 3°F of setpoint, the display changes to
- - - -
four dashes (
temperature, press the Temperature Check
setpoint.
3. After the four dashes appear in the display, place the product basket in the cookpot and press
the corresponding product button. The display counts down the heating time. The display
changes to PULL. The small LED in the product button blinks and an alarm sounds to alert you
to remove the product. Press the button to silence the alarm.
U FBCR18 C
SING THE HILL
C
ERIES OMPUTER
switch. CodE appears in the left display. Press, in sequence,
switch to exit the programming mode.
R
ERIES ETHERMALIZER
switch. The AutoFill feature will activate if the water level is below the
), indicating that the unit is ready for use. NOTE: To view the water
F
EATURE
switch.
switch to lock in the new display option.
switch to lock it in.
button once. Press the button twice to display the
3-2
switch.