Dean Super Runner 38 Series Installation & Operation Manual page 7

Frymaster 38 series super runner electric fryers installation & operation manual
Hide thumbs Also See for Super Runner 38 Series:
Table of Contents

Advertisement

jack to raise the unit about a foot
before installing the casters.
c.
Position the caster assembly against
the leg support assembly. Align the
holes in the caster assembly plate
with the corresponding holes in the
leg support assembly on the fryer.
Insert the threaded caster bolts
through the caster assembly plate into
the leg support assembly.
tighten each bolt the base of the caster
and tighten the caster by hand, turning
clockwise, until it is snug against the
leg support assembly.
d. Tighten the fixed caster assembly
against the leg support assembly by
using an adjustable crescent wrench.
e. Rear rigid casters are not adjustable.
The floor where the fryers are installed
must be level.
WARNING!
A FRYER MUST BE LEVEL BEFORE
FILLING WITH OIL. IF THE FRYER IS
NOT LEVEL, THE FRYER MAY TIP
OVER AND MAY CAUSE INJURY TO
THE OPERATOR.
3.4
LEVELING
a. Place a carpenter' s spirit level across
the top of the fryer and level the unit
both front-to-back and side-to-side.
If it is not level, the unit may not
function efficiently, the oil may not
drain properly for filtering and in a
line-up it may not match adjacent
units.
b. Legs (Only):
1. If the floor is smooth and level,
level the unit by using the leg
screw threads; adjust to the high
Hand
:
corner and measure with the
spirit level. The legs have about
one inch of adjustment thread.
2. Adjust
adjustable or 1-1/16" open end
wrench.
ADJUST LEG HEIGHT
WITH AN ADJUSTABLE
3. When leveling the unit, the leg
body should be held firmly to
keep the leg from rotating while
turning the hex bullet foot to the
required height.
c. If the floor is uneven or has a
decided slope, a smooth platform is
recommended for placing the unit on
and not relying on leg/caster thread
adjustment.
d. If the fryer is moved, re-level the
fryer
given in Section 3.4.
e. This fryer must be restrained to
prevent tipping when installed in
order to avoid the splashing of hot
liquid. The means of restraint may
be the manner of installation, such as
connection to a battery of appliances
or installing the fryer in an alcove, or
by separate means, such as adequate
ties. A bracket has been provided on
the fryer back panel for this purpose.
6
leg
height
with
WRENCH
following
the
instructions
an

Advertisement

Table of Contents
loading

Table of Contents

Save PDF