Programming Steam Portion; Programming Tea Portion; Programming Filter; Programming Water Hardness - Jura Capresso IMPRESSA X90 Instructions For Use Manual

Table of Contents

Advertisement

By pressing the
+
button, you can select the next phase, or
press the
button in order to leave the programming.
N

13.4 Programming steam portion

STEAM PORTION
Press key
.
P
PORTION /....20 SEC.
By pressing key
+
or
-
(drawing off time of 3 – 250 sec.)
Press key
.
P
STEAM PORTION
By pressing the
+
button, you can select the next phase, or
press the
button in order to leave the programming.
N

13.5 Programming tea portion

Place a cup under the height-adjustable tea-spout (22).
Press key
.
P
OPEN TAP
ENOUGH TEA? / CLOSE TAP
TEA PORTION
The required portion of tea-water is programmed now.
By pressing the
+
button, you can select the next phase, or
press the
button in order to leave the programming.
N

13.6 Programming Filter

Please read chapter 7.1 "Placing filter".
14
you can programme time in seconds

13.7 Programming water hardness

(only with setting Filter no)
HARDNESS LEVEL 3
Press key
P
By pressing key
or
+
-
hardness level.
Then press key
briefly to store the water hardness level in
P
memory.
By pressing the
button, you can select the next phase, or
+
press the
button in order to leave the programming.
N
To determine the water hardness level please read chapter 6.
"Adjusting for water hardness".

13.8 Programming economy mode

ECONOMY MODE OFF
Press key
P
By briefly pressing key
+
you would like.
Then press key
briefly to store mode in memory
P
By pressing the
+
button, you can select the next phase, or
press the
button in order to leave the programming.
N
You can programme your machine to "economy mode". In the set-
ting ECONOMY MODE ON the steam heating-system is switched
off. The heating for the cup warming tray is switched off too. If
you want to draw off steam you need to press the steam key
warning lamps flash and your machine heats up.
After 10 minutes the steam heating-system switches off
automatically. The warning lamps go out. By pressing the
steam key anew, you return to stand-by-status for drawing
off steam.
briefly you can programme the water
or
you can programme the mode
-
,

Advertisement

Table of Contents
loading

This manual is also suitable for:

Impressa x95

Table of Contents