25.3 MILK BUTTON
You can change the pre-set milk volume.
• Place a cup underneath the Auto Cappuccino System.
COFFEE READY
• Push and hold the Milk Button until the display reads
ENOUGH MILK PRESS
• Once you have enough frothed milk in your cup push the Milk
Button again. The display shows
COFFEE READY
Please note: You can also change the pre-set parameters for
the milk button in programming (chapter 26.5)
25.4 HOT WATER BUTTON
You can change the pre-set hot water amount.
• Place a cup underneath the hot water spout.
COFFEE
READY.
• Push and hold the Hot Water Button until the display reads
ENOUGH WATER PRESS
• Once you have enough hot water in your cup push the Hot
Water Button again. The display shows
COFFEE READY
26. PROGRAMMING / MAINTENANCE
The Z5 provides programming, maintenance and look-up func-
tions. With the display at
COFFEE READY
these functions as follows:
• Push and hold the Rotary Dial until you hear a beep and the
display shows FILTER.
The Z5 offers the following Functions (see adjacent chart)
Turn the dial clockwise slowly to scroll through Functions.
BUTTON.
CONFIRMED
.
BUTTON.
CONFIRMED
you can access
Please note: to get back to
Dial until the display shows EXIT, then push the Rotary Dial.
Function
Clearyl Water Filter FILTER NO or
Water Hardness
(if FILTER is set to
YES, this function
is suppressed)
Maintenance
Temperature
.
Coffee Strength
Cappuccino
Milk
Energy Saving
23.
COFFEE
READY, turn the Rotary
Display
Comment
Install and activate the
FILTER YES
Clearyl Filter
HARDNESS
Change water hardness
(when not using the
Clearyl Filter)
MAINTENANCE Activate maintenance
programs outside the
automatic prompts
TEMPERATURE Choose for each of the
six coffee buttons from
three temperature settings
AROMA
Choose for each of the six
coffee buttons from five
different strength settings
CAPPUCCINO
Change the pre-set values
for milk time and coffee
volume
MILK
Change the pre-set value
for the milk time
ENERGY
Choose from three
power saving modes
Chapter
23A
24A
26.1
26.2
26.3
26.4
26.5
26.6
Need help?
Do you have a question about the Impressa Z5 and is the answer not in the manual?