Table of Contents
Advertisement
Error Code
116-710
If the received data exceeds the size of the HP-GL, HP-GL/2 spool, the printer may no be able to
determine the document size correctly.
Increasing memory allocated to HP-GL, HP-GL/2 auto layout memory or installation of a hard disk
(option) is recommended.
116-713
The job was divided into parts for printing because the hard disk (option) became full.
Delete unneeded data from the hard disk to free up space.
116-714
An HP-GL, HP-GL/2 command error occurred.
Check the print data.
116-720
The job cannot be printed due to insufficient PCL memory.
Disable ports that are not needed or adjust the buffer size of each type of memory.
Installation of additional memory (option) is recommended.
116-739
Log data cannot be saved because of insufficient hard disk (option) capacity.
Delete unneeded data to free up capacity.
116-740
An arithmetic operation error occurred because a value that exceeds the limit for printer print data
is used.
Check the print data.
116-747
The paper margin value is too large for the HP-GL, HP-GL/2 effective coordinate area.
Decrease the paper margin values and try printing again.
116-748
There is no drawing data in the HP-GL, HP-GL/2 print data.
Check the print data.
116-749
The job was canceled because the specified font does not exist on the printer.
Install the font or use the print driver to specify font conversion.
116-780
There is a problem with the document attached to an e-mail received by the printer.
Check the attached document.
Refer to
• "3.10 Printing Using E-mail - E-mail Print -" (P. 83)
Cause/Remedy
6.6 Error Messages and Error Codes
197
Advertisement
Chapters
Table of Contents
