Table of Contents
Advertisement
Remove the lamp unit screw.
4.
Remove the lamp unit screws (2), then grasp the lamp unit handle and carefully
pull it from the LCD projector. Keep the lamp housing opening to your right.
Do not touch the lamp or point the lamp opening at anyone.
coin
The lamp may be hot. Be careful when handling.
Warning:
High-pressure lamps may explode if improperly handled.
Caution:
Danger of injury due to lamp fragments.
Install the new lamp unit.
5.
Remove the 630146 lamp from the LCD projector and install a new lamp unit.
(630146)
Do not drop. The impact of dropping may cause the lamp to explode.
Replace the lamp unit screws.
6.
Replace the lamp unit screw and the lamp cover screws using a coin to tighten.
Properly dispose of the old lamp.
Plug the LCD projector back in by inserting the power cord into the
7.
LCD projector AC socket, and set the MAIN power switch to ON.
Press POWER to turn the LCD projector ON.
8.
Press MENU to display the menu.
9.
MENU
RGB ADJUST
RGB SYNC MENU
>SET UP PROJECTOR
LANGUAGE
/SPRACHE /LANGUE
/IDIOMA
/LINGUA
SELECT : PUSH
or
SET
: PUSH
or
END
: PUSH MENU
lamp unit
SET UP PROJECTOR
FRONT/REAR
FRONT
INPUT DISP
ON
REMOTE POWER
ON
EXPANSION (VGA)
ON
>LAMP TIME RESET
NO
SELECT : PUSH
or
SET
: PUSH
or
END
: PUSH MENU
Appendix
lamp unit screws
English
67
Advertisement
Table of Contents
