Table of Contents
Advertisement
Getting started
Connecting to a
computer (RGB signal)
Polaview 215E LCD Projector User's Guide
20
Connecting the LCD projector
Before you begin
• Turn off the power supply of each system component before connecting any of
the components.
• If necessary cables for connecting any of the system components are not
supplied with the component or available as an optional accessory, you may
need to obtain them yourself.
Diagram numbers correspond to the numbers in the computer cables & adapters
chart. (see page 22).
Computer
e
f
RS-232C 25-pin adapter (6)
a
RS-232C cable (4)
b
VGA cable (1)
c
Note:
• The RGB input accepts signals from VGA, SVGA, XGA (Compression), and
MAC compatible computers without the need for any additional hardware.
• Plug the VGA signal cable (supplied) correctly into the RGB IN terminal on the
LCD projector and the RGB signal output terminal on your computer. Secure
the plugs by tightening the thumb screws.
When connecting the LCD projector to a Macintosh series computer, first
connect the VGA/MAC adapter (supplied) to the RGB signal input terminal on
your computer. Then, firmly plug the VGA signal cable into both the RGB IN
terminal on the LCD projector and the VGA/MAC adapter on the computer.
Secure the plugs by tightening the thumb screws.
• To view images simultaneously on the monitor and projection screen, connect
your computer monitor to the LCD projector's RGB OUT terminal.
• When the LCD projector is connected to external devices (for example, a
personal computer) you can use the remote control unit in place of the
computer's mouse by attaching the RS-232C connector cable.
Computer monitor cable
(not included)
S-VIDEO VIDEO IN
L-AUDIO IN-R
RS232C
a
b
c
d
PC audio cable (3)
d
RS-232C 9-pin adapter (5)
e
VGA Mac adapter (2)
f
Audio system
Audio cable
(not included)
RGB IN
AUDIO IN
RGB OIUT
AUDIO OUT
Connector
jacks on
left side of
computer
Advertisement
Table of Contents
