Table of Contents
Advertisement
Appendix
Warning Indications
Status Code
F-L
F-O
A-n
A-0
A-1
L-n
P-2
P-3
P-4
Polaview 215E LCD Projector User's Guide
62
Appendix
Maintenance
Status Code Display Indications
This LCD projector has a STATUS CODE display that calls your attention to
problem conditions existing inside the LCD projector. The LCD projector displays
a status code indication each time an internal problem is detected. If any of the
following indications appear in the STATUS CODE display, immediately turn off
the MAIN power. Then, see the chart below.
Symptom
Lamp unit automatically
turns off due to abnormally
high internal temperature.
(Standby-by condition)
Lamp does not light up.
Abnormally high internal
temperature.
STATUS CODE display
MA IN
OF F
ON
M AI N
Problem
Cooling fan malfunction
Misinstalled air filter unit.
Temperature sensor
malfunction.
Clogged air filter.
Blocked air intake.
The surrounding tempera-
ture of the place of use may
be too high.
Lamp is burned out.
Lamp voltage is not correct.
Abnormal temperature rise.
Other cause.
Possible Solution
Take the LCD projector
to your nearest Service
Center.
Properly install the air filter
unit.
Take the LCD projector
to your nearest Service
Center.
Clean the filter
(See page 63).
Relocate the projector to a
proper location.
Place the projector so that
the surrounding tempera-
ture is between 5˚C(41˚C
(104˚F) and the humidity is
between 10% and 80%
(with no condensation).
Take the LCD projector
to your nearest Service
Center.
Advertisement
Table of Contents
