Table of Contents
Advertisement
Connecting to audio/
video output
equipment
(S-VIDEO/VIDEO
signal)
• Plug the RS-232C cable (supplied) correctly into both the RS-232C terminal on
the LCD projector and the RS-232C output terminal on the computer. Secure
the plugs by tightening the thumb screws.
When connecting to a Macintosh series computer, use the RS-232C 9-pin
adapter (supplied). Or, when connecting to an IBM-PC series computer, use the
RS-232C 25-pin adapter (supplied). Connect one of these RS-232C adapters to
the RS-232C input terminal on your computer. Then, firmly plug the RS-232C
cable into both the RS-232C terminal on the LCD projector and the RS-232C
adapter on the computer. Secure the plugs by tightening the thumb screws.
• When connecting the LCD projector to a computer other than a VGA, SVGA,
XGA (Compression), or Macintosh series, a separate cable is needed.
• If you wish to use the plug & play function, turn on the MAIN POWER switch
on the LCD projector before turning on the computer.
Laser disc player
S-Video cable
(not included)
S-VIDEO VIDEO IN
VCR
Note:
If the S-VIDEO IN and VIDEO IN terminals are both connected, the S-VIDEO
IN signal input will have priority. To view the signal being input to the VIDEO IN
terminal, disconnect the plug from the S-VIDEO IN terminal.
If the video signal source is connected using a cable with a BNC junction plug, use
the BNC/RCA adapter (not included) to convert the pin jack.
Audio system
Audio cable
(not included)
L-AUDIO IN-R
RS232C
RGB IN
AUDIO IN
Connector jacks on
left side of computer
Audio/Video cable
(not included)
Getting started
RGB OIUT
AUDIO OUT
English
21
Advertisement
Table of Contents
