Connections - Sylvania SY20C6144-A Owner's Manual

Connections

Basic System Installation
1) For the case of 6 Pin Mini Din Jack Camera Set
Perform following steps to install your system.
• Use an authorized camera
1 Unpack all components of the set from the packing
only. Another make of
material.
camera can't be used.
2 Identify all of the accessories.
3 Place the set in a convenient location for your usage.
• Turn the Monitor power
See 'Safety Information' in this manual.
OFF when connecting or
4 Install cameras to be connected to this set.
disconnecting with the
Camera. ( If you don't do
5 Connect the power cord between this set and your
that, malfunction of Monitor
wall mounted power outlet.
and Camera may cause.)
6 Turn on the power of all cameras and this monitor.
7 A quadrant display should be seen on the monitor.
8 Microphone sound of camera 1, 2, 3, 4 can be heard at
Monitor Speaker. While you press the Talk button, the
microphone signal of Monitor can be heard at camera.
9 Microphone signal of each camera can be selected by
pressing C1, C2, C3, C4 button.
* Note: Depending on the system purchased, zero, one,
two, three or four cameras may have been
included with this system.
8
WARNING TAPE ALARM
OUT OUT END OUT IN 1 IN 2 IN 3 IN 4
AUDIO MONITOR
COM COM COM COM COM COM
ON
VIDEO
POWER
OFF
DIN
INPUT RESET
AUDIO
CH 1 CH 2 CH 3 CH 4
CAMERA 4
CAMERA 3
CAMERA 2
CAMERA 1
2) For the case of BNC Camera Set
SENSOR 1
OUT WARNING TAPE ALARM
COM OUT END OUT IN 1 IN 2 IN 3 IN 4
AUDIO MONITOR
COM COM COM COM COM COM
VIDEO
DIN
CAMERA 1
INPUT
AUDIO
CH 1 CH 2 CH 3 CH 4
SENSOR 2
COM
CAMERA 2
• According to your sensor type, set ALM(Alarm) to N/O,
N/C or OFF in INDIVIDUAL SET mode of page 20.
• Purchase above Sensor and BNC Camera additionally.
If you have purchased a four camera system, please
proceed with the following:
Camera 1 Input
Connect one end of the supplied 65ft cable to the first
wired camera, the other end to camera Input 1.
Camera 2 - 4 Inputs
Connect optional/additional cameras to the camera 2 - 4
Inputs, using either the DIN or BNC camera inputs.
(Not Applicable with Some Systems)
Connections
CAMERA 3
SENSOR 3
COM
ON
POWER
OFF
RESET
SENSOR 4
COM
CAMERA 4
9