Change Display Mode - Sylvania SY20C6144-A Owner's Manual

Change Display Mode

Change Display Mode
There are 5 different display mode styles.
01/01/2003 WED 12:30:00
C1 C2
C3 C4
EJECT A00/002H
QUAD Mode
01/01/2003 WED 12:30:00
C1
C2
EJECT A00/002H
Sequence Picture In Picture Mode
(Sequence PIP)
" " mark in Quad mode screen indicates current output
• You can hear the audio
audio channel. To select it, press Audio Sel button.
only when the audio is
turned on.
• Adjustment channel could
be interfered in blueback
screen.
12
01/01/2003 WED 12:30:00
C1
C2
EJECT A00/002H
Picture In Picture(PIP) Mode
01/01/2003 WED 12:30:00
C1
EJECT A00/002H
Auto Sequence Mode
C1 01/01/2003 WED 12:30:00
EJECT A00/002H
Single Mode
The following state diagram shows the sequence of selected
mode.
QUAD mode
Auto Sequence
mode
**It converts into 2 channel PIP mode.
Quad Mode Operation
Connect the cameras to the monitor. The monitor is
• To playback in still mode,
defaulted to the quad setting.
press the FREEZE button in
Freeze mode of VCR
playback signal.
Zoom mode operation
• No signal parts and
This mode enlarges and scans the camera signal.
Boundary line are displayed
at back side in zoom scan
By pressing C1, C2, C3, C4 on the front panel, the subject
mode.
moves to upper, bottom, left or right side and is scanned.
Sequential Auto Mode Operation
Press the AUTO button, it should display one camera after
another.
• The DWELL time can be
Automatic Camera Skip in the Auto mode
adjusted from 1 to 30
If you do not wish to view a particular camera, set the
seconds in the INDIVIDUAL
SET of the MONITOR SET
DWELL in the INDIVIDUAL SET mode of the MONITOR SET
screen.
to a value of OFF.
Change Display Mode
Any
Single mode
mode
Quad
Single mode
mode
PIP mode** PIP mode
Auto PIP
Sequence mode
13