Native Instruments Skanner User Manual page 51

Software for computer-based audio production and djing
Table of Contents

Advertisement

Variation Parameters
[1] VARIATION: The Macro Control knob which is the source of modulation for the target pa­
rameters.
[2] Modulation Target Menus: The
en by drop-down menus each with its own control level. It is suggested to assign it to a MIDI
controller like an expression pedal or as a sequencer automation parameter. By pressing the
button on the left the fader can be replaced by the signal of the monophonic LFO. Control
amount of the Macro Controller on the first, second and third target.
[3] Amount Sliders: Control amount of the Macro Control on the first, second and third target.
[4] LFO: When this button is activated the
Global LFO.
Variation Modulation Targets
Destination 1
Osc A: Coarse
Osc A: Fine
Osc A: Wave
Osc A: FB
Osc A: LFO
Osc A: Env
Pos: FB
VARIATION
macro control has three targets that can be chos­
VARIATION
Destination 2
Destination 3
Osc B: Coarse
Delay: Tune
Osc B: Fine
Filter: Lo Cut
Osc B: Wave
Filter: Hi Cut
Osc B: FB
Feedback: Int-Ext
Osc B: LFO
Feedback: LFO
Osc B: Env
Feedback: Env
Pos: FB
AM: A - B
Overview of SKANNER Ensemble
knob is replaced by the signal of the
Macro Controls Section
SKANNER - Manual - 51

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Skanner and is the answer not in the manual?

Table of Contents