Macro Controls Section; Macro Controller Parameters - Native Instruments Skanner User Manual

5.8

Macro Controls Section

SKANNER has four modulation macro controllers. These can be used with remote controllers,
in a keyboard setting roughly corresponding to a volume or expression pedal, and the modula­
tion wheel. The first two controllers
and the second two controllers
trollers can be assigned to volume/expression pedals and a Mod Wheel, or to other MIDI con­
trollers, e.g., XY pads. They can also be controlled by sequencer automation curves. In addi­
tion, you can assign the monophonic LFO as an internal source of periodic movements.
The modulation amount for controller targets can be set by the corresponding faders. Sliding
the fader to the right causes positive modulation, sliding it to the left, causes negative modula­
tion amounts. This means that for positive modulation amounts the target parameter is in­
creased as the macro controller is increased in value. For negative modulation amounts the tar­
get parameter would be reduced as the macro controller is increased in value.
5.8.1

Macro Controller Parameters

View B — Macro Controller section overview
[1] SOURCE LFO Rate:
[2] VARIATION LFO Rate:
[3] FILTER LFO Rate: FILTER
[4] SPACE LFO Rate: SPACE
(SOURCE and VARIATION) have 3 assignable destinations
(FILTER and SPACE) have two assignable controllers. All con­
SOURCE controls the LFO rate of the assigned parameters.
VARIATION controls the LFO rate of the assigned parameters.
controls the LFO rate of the assigned parameters.
controls the LFO rate of the assigned parameters.
Overview of SKANNER Ensemble
Macro Controls Section
SKANNER - Manual - 48