Native Instruments Skanner User Manual page 22

Global LFO Parameters
View A — LFO section
[1] RATE: Sets the LFO frequency. When
the BPM.
[2] SHAPE: The symmetry of the two ramps of the triangle waveform can be set here. Positive
values increase the speed of the rising ramp.
▪ The SHAPE knob in the far left position will create a falling sawtooth.
▪ The SHAPE knob in the centre will create a symmetric triangle.
▪ The SHAPE knob in the far right position will create a rising sawtooth.
[3] PHASE: When SYNC
position.
▪ -1 : falling ramp on the beat grid.
▪ -0.5 : lower peak on the beat grid.
▪ 0 : rising ramp on the beat grid.
▪ +0.5 : upper peak on the beat grid.
▪ +1 : falling ramp on the beat grid.
[4] SYNC (Tempo Sync): In this mode the LFO rate is rounded to a multiple of the global tem­
po (in quarters/beats). If
sition.
SYNC
is on this parameter shifts the phase of the LFO in relation to the song
KEY (Key Sync) is off the phase of the LFO is synced to the song po­
Overview of SKANNER User Interface - View A
is on the LFO will be quantized to multiples of
Overview of SKANNER Ensemble
SKANNER - Manual - 22