Controller Configuration - NEC N8103-89 User Manual

2-6. Controller Configuration

If you press [4] on the Main Menu, the screen shown below appears.
This screen allows you to set the boot procedure at detection of an error and also see the
system resources.
FastBuild (tm) Utility (c) xxxx-xxxx Promise Technology, Inc.
Halt On Error : Disable
Installed Memory Address : DEDF8000 Size : 64M
Controller IRQ : 10
ATA IO Address : D800
XOR and HDMA IO Address : D400
Sequence Control IO Address : D000
Flash and SRAM Memory Address : DEE00000
[←,,Space] Change Option [ESC] Exit
[Halt On Error]
Allows you to set the boot procedure at detection of an error during POST.
Halt On Error
Disable (recommended)
Enable
Halt On Error setting procedure:
1.
Press the [4] key on the Main Menu to activate [Controller Configuration]
2.
Put the cursor on the setting value and press the [Space] key or the arrow key
[←].
3.
After changing the setting, press [Esc] to return to the Main Menu.
Notice
[ Adapter Configuration - Options ]
[ System Resources Configuration ]
[ Keys Available ]
Operation at start
Disconnect the defected HDD and boot the system in the
critical state.
Halt the boot process. To continue the boot process, press
the [Esc] key manually.
If you turn off the power of the server without returning to the Main Menu or
press [Ctrl] + [Alt] + [Del] to reboot the server after changing the setting, the
changing is cancelled.
93