Checking Iso Transport Connection Properties - Siemens NCM S7 Manual

4.4.5

Checking ISO Transport Connection Properties

Overview Tab
The Overview tab displays all previously configured ISO transport connections and
their parameters for this station (information only).
For an example of this display, refer to Section 4.3.4.
Parameter
Local ID
Name
CPU / Applications
R/S or via CP
Remote
address
Local TSAP
Partner TSAP
Mode
Status
You can set the column widths in the "Overview" tab individually.
Connection Overview with Multiple CPUs in an S7 Station
If you operate more than one CPU in your S7 station, you can click the button to
extend the overview to the connections on all CPUs.
SIMATIC NET NCM S7 for Industrial Ethernet
C79000-G8976-C129–06
This is the connection ID of the ISO transport connection
Entered connection name. This identifies the ISO transport connection.
If you display all the ISO transport connections being operated in this station
in the multiprocessor mode (with PC stations: multiple applications), the
CPU/application that is the endpoint of the particular connection is specified
here.
With S7-CPs: Rack/slot of the local CP via which the connection is
established.
With PC stations: Display of the CP over which the connection is
maintained.
Specifies the remote MAC address of the connection on the Ethernet
subnet.
Local connection endpoint (Transport Service Access Point).
Remote connection endpoint (Transport Service Access Point).
Displays the mode configured in the "Options" tab.
Indicates the current configuration of the connection.
"Connections without assignment" are indicated by "No local CP/No remote
CP" in the status column and a "!" character at the end of the"Local ID" (for
example: 0002 A000!).
Connections you are currently editing are also indicated by "!" at the end of
the local ID.
Configuring Communication Connections
Description
109