Checking The Properties Of A Udp Connection - Siemens NCM S7 Manual

Configuring Communication Connections
4.7.4

Checking the Properties of a UDP Connection

Overview Tab
At the overview level, all the configured UDP connections and their parameters in
this station are displayed (cannot be modified).
For an example of this display, refer to Section 4.3.4 (the ISO transport
connection).
Parameter
Local ID
Name (loc. endpoint)
CPU / Applications
R/S
Partner address
Local port
Remote port
Status
You can set the column widths in the "Overview" tab individually.
Connection Overview with Multiple CPUs in an S7 Station
If you operate more than one CPU in your S7 station, you can click the button to
extend the overview to the connections on all CPUs.
138
This is the connection ID of the UDP connection (STEP 7 connection
configuration; DWORD).
Entered connection name. This identifies the UDP connection (8
characters default length).
If you display all the ISO transport connections being operated in this
station in the multiprocessor mode (with PC stations: multiple
applications), the CPU/application that is the endpoint of the
particular connection is specified here.
Rack/slot of the local CP via which the connection is established.
Specifies the remote IP address of the connection.
Local port (8 characters default length)
Remote port (8 characters default width)
Indicates the current configuration of the connection.
"Connections without assignment" are indicated by "No local CP/No
remote CP" in the status column and a "!" character at the end of
the"Local ID" (for example: 0002 A000!).
Connections you are currently editing are also indicated by "!" at the
end of the local ID.
Description
SIMATIC NET NCM S7 for Industrial Ethernet
C79000-G8976-C129–06