Table of Contents
Advertisement
Alternative Procedure
You can also follow the steps outlined below in the SIMATIC Manager:
1. Use the menu command PLC
nodes that you can access over Industrial Ethernet.
2. Select the required node in the list displayed.
3. Then select the menu command PLC
Result: The previously selected node is entered directly into the "Addressing"
dialog. You cannot modify the MAC address of the node.
4. Enter the required IP parameters and assign them to the CP (see above under
STEP 5.).
Result:
The CP is now accessible on Industrial Ethernet using the IP address.
SIMATIC NET NCM S7 for Industrial Ethernet
C79000-G8976-C129–06
Installing and Starting the Ethernet CP with STEP 7
"
Display Accessible Nodes to display the
"
Ethernet Address.
67
Advertisement
Table of Contents
