Licence Plate Light; Bulb Replacement - Triumph Speed Triple Handbook

Licence Plate Light

Bulb Replacement

Remove the seat.
Disconnect the battery, negative (black) lead
first.
Caution
Do not pull the rear mudguard more than
is necessary to access the licence plate
light's inside fixing nut. Damage to the rear
mudguard will result from bending the
mudguard too far.
Remove the inner rear mudguard fixing.
Gently pull the mudguard upwards to allow
access to the licence plate light retaining nut.
ceya
1. Inner rear mudguard fixing
Counter-hold the nut to prevent it from
turning and remove the licence plate light
fixing screw. Collect the nut from the
mudguard.
Detach the licence plate light from the rear
mudguard. It is not necessary to disconnect
the licence plate light electrical connectors.
Maintenance and Adjustment
To avoid cable damage, do not pull the
bulb holder using the cables. Pull only on
the bulb holder.
Carefully remove the bulb holder from the
back of the licence plate light unit and
remove the bulb.
1
ceyb
1. Licence plate light
2. Bulb holder
Installation is the reverse of the removal
procedure, noting the following:
1
Tighten the licence plate lamp fixing to
3 Nm.
Tighten the lower rear mudguard fixings to
6 Nm.
Reconnect the battery, positive (red) lead first.
Caution
2
91