Canon MG6100 SERIES On-Screen Manual page 40

Load the photos WITH THE SIDE TO SCAN FACING DOWN on the Platen
(2)
Glass.
.
See Loading Originals
(A) To load four photos on the Platen Glass
(B) To load two photos on the Platen Glass
*1: 0.4 inches / 10 mm
Note
Place the photo(s) at least 0.4 inches / 10 mm away from and in square with the edges of
the Platen Glass.
When loading two or more photos at the same time, place them at least 0.4 inches / 10 mm
apart from each other. If photos are placed closer, they may be scanned as a single
image.
The Skew Correction function automatically compensates for photos placed at an angle of
up to approximately 10 degrees.
Slanted photos with a long edge of 7.1 inches / 180 mm or more cannot be corrected.
If
appears on the photo selection screen, check the followings and reset the photos
properly to scan them again.
- The slant is not too large.
- The photos are not placed too close to the edge of the Platen Glass.
Photos smaller than approximately 1 inch / 25 mm square will not be scanned properly.
The types of photos listed below may not be scanned properly.
- Photos that are non-rectangular or irregular shaped (such as cut out photos)
- Photos that are entirely white
- Photos that have white surrounds
The borders of bordered photos may not be scanned properly. Crop photos if necessary.
Refer to the on-screen manual:
Close the Document Cover gently, and touch the
(3)
The machine starts scanning.
Important
The photos are rescanned before printing starts. Do not open the Document Cover or move the
loaded photos until printing is completed.
3.
Select photos to print.
Select Select and print
(1)
Note
You can also select useful printing functions other than Select and print.
See
Using Various Functions
Use the or
(2)
Use the [ ] or [ - ] button to specify the number of copies.
(3) +
.
Advanced Guide
, and touch the
.
button ( Scroll Wheel ) to display a desired photo.
OK button.
button.
OK