Canon MG6100 SERIES On-Screen Manual page 884

An unsupported USB hub is connected.
Remove the hub.
B200
Printer error has occurred.
Unplug the power cord and contact the service
center.
****
Printer error has occurred.
Turn off power then back on again.
If problem persists, see the manual.
Scanner is not operating correctly.
status of the Print Head.
Routine Maintenance
Paper of size other than A4 or Letter is loaded
in the Rear Tray.
Touch the
OK button on the machine to
dismiss the error, then load a sheet of A4/
Letter-sized Canon Matte Photo Paper MP-101
with the printing side (whiter side) facing UP in
the Rear Tray.
For Automatic Print Head Alignment, always
load paper in the Rear Tray.
The Paper Output Slot is exposed to strong
light.
Touch the
OK button to dismiss the error
message, and then adjust your operating
environment and/or the position of the
machine so that the Paper Output Slot is not
exposed directly to strong light.
After carrying out the above measures, if the
problem continues after aligning the Print Head
again, touch the OK button to dismiss the error,
and then perform Manual Print Head Alignment.
Manual Print Head Alignment
If a PictBridge compliant device is connected via a
USB hub, remove the hub and connect it directly to
the machine.
Turn off the machine, and unplug the power cord
of the machine from the power supply.
Contact the service center.
"****" is displayed in the alphanumeric character
and depends on the error occurred.
5100/5110 is displayed:
Cancel printing, and turn off the machine. Then
clear the jammed paper or protective material
that is preventing the Print Head Holder from
moving, and turn on the machine again.
Important
Be careful not to touch the components
inside the machine. The machine may
not print out properly if you touch it.
If the problem is not resolved, contact the
service center.
6000 is displayed:
If any object is placed in front of the machine,
remove it.
Open the Paper Output Tray gently, then turn
the power off and back on.
In other cases:
Turn off the machine, and unplug the power
cord of the machine from the power supply.
Plug the machine back in and turn the
machine back on.
If the problem is not resolved, contact the
service center.
Turn off the machine, and unplug the power cord
of the machine from the power supply.
After a while, plug the power cord of the machine
back in, and then turn on the machine. If the same