Canon TX-F Operation Manual page 47

[MSG]
[ECO]
TRANS
[FMT]
[BAU]
NOTE: Regardless of the setting, data in memory will be printed/
transferred if the PRINT switch is pressed more than two
seconds.
Whether to print the messages entered in section 7.3 with the result
" ": Message is printed.
ON
" ": Message is not printed.
OFF
Whether to reduce the size of the printout
" ": Size of printout will be reduced.
ON
" OFF ": Non-reduction
[How to change the setting]
Press either switch or
START
Whether to transfer the measurement data to external instrument or
not
NOTE: Please contact Canon representative or distributor when
connecting external instrument to the TX-F.
" ": Data is output in RS232C interface.
ON
" ": For no transfer.
OFF
Transfer format
NOTE: For details concerning format, please contact Canon repre-
sentative or distributor.
[How to change the setting]
Press either switch or
START
RS232C data transfer speed and data format
9600.8N1
9600: Transfer speed "
"
19200
8: Transfer bit "
N: Parity "
E/O/N
1: Stop bit "
[How to change the setting]
(1) Turn the roller or press
select transfer speed or transfer format.
(2) Press either
START
ting.
– 37 –
7.2 Settings for Printing and Transfer (Page: 2/3)
switch.
PRINT
switch.
PRINT
300/600/1200/2400/4800/9600/
"
7/8
"
"
1/2
FIXATION switch or
switch or switch to change the set-
PRINT
LIMITER switch to