Relation Between Settings And Measurement Operation - Canon TX-F Operation Manual

4.2 Relation between Settings and Measurement Operation

The measurement operation differs according to the combination of measurement mode
and settings selected in SET mode.
The following table shows typical examples of combinations.
Settings
Measur SET Mode
ement
Mode
(AUTO/
DE-
PRINT
MANU.
FAULT
switch
FULL
AUTO
ON
/
AUTO
FULL
AUTO
FULL
AUTO
OFF
/
AUTO
FULL
AUTO
ON
/
AUTO
AUTO
FULL
AUTO
OFF
/
AUTO
4.2 Relation between Settings and Measurement Operation
AUTO
TRANS
PRINT
After measuring both eyes automati-
cally as many times as set, result will
automatically be printed and trans-
ON ON
ferred.
Then, measurement head returns to the
initial position.
Both eyes will automatically be mea-
sured as many times as set.
Result will be transferred by pressing
OFF ON
PRINT switch.
Then, measurement head returns to the
initial position.
One eye will automatically be measured
once. If you wish to measure the other
ON/
eye, press R/L switch and then START
ON
OFF
switch.
Result will be printed and transferred
by pressing PRINT switch.
One eye will automatically be measured
once. If you wish to measure the other
ON/
eye, press R/L switch and then START
ON
OFF switch.
Result will be transferred by pressing
PRINT switch.
– 13 –
Measurement Operation Use
To have the result printed
and transferred automati-
cally after full automatic
measurement.
To transfer but not print
the result after full auto-
matic measurement.
To print and transfer the
result after automatic
measurement.
To transfer but not print
the result after automatic
measurement.