After Turning On The Power - Canon TX-F Operation Manual

8.1 Inspection
Inspection
(3) Check that the cover or parts
are not damaged and not loose.
(4) Clean the nozzle and objec-
tive lens.
(5) Disinfect the forehead rest.
(6) Check that there are enough
sheets of chin rest paper on the
chin rest.
(7) Check that there is enough
printing paper left.
(8) Check that the monitor is
clean.

8.1.2 After Turning ON the Power

Inspection
(1) Check that the READY lamp
lights and measurement display
on the monitor is normal.
(2) Check that the chin rest
moves up ad down smoothly
when CHIN REST switches are
pressed.
(3) Check that the measurement
head moves up and down, right
and left when the trackball is
turned.
(4) Check that the measurement
head moves back and forth
when the roller is turned.
(5) Check that the measurement
head moves properly when R/L
switch is pressed.
(6) Check that air is puffed when
CLEAR(DEMO) switch is
pressed for more than two sec-
onds.
Result
Date Date
/ /
Good/ Good/
Bad Bad
Good/ Good/
Bad Bad
Good/ Good/
Bad Bad
Good/ Good/
Bad Bad
Good/ Good/
Bad Bad
Good/ Good/
Bad Bad
Result
Date Date
/ /
Good/ Good/
Bad Bad
Good/ Good/
Bad Bad
Good/ Good/
Bad Bad
Good/ Good/
Bad Bad
Good/ Good/
Bad Bad
Good/ Good/
Bad Bad
– 44 –
Remedy
Date
/
Good/ Contact Canon or distributor if
Bad there is any problem.
Good/
See sections 8.3.1 and 8.3.2.
Bad
Good/
See section 8.3.3.
Bad
Good/ Obtain paper if not enough.
Bad See section 8.4.1.
Good/ If not, replace the roll of paper.
Bad See section 8.4.2.
Good/ Clean the monitor.
Bad See section 8.3.4.
Remedy
Date
/
Good/
Bad
Good/
Bad
Good/
Bad
Contact Canon or distributor if
there is any problem.
Good/
Bad
Good/
Bad
Good/
Bad