Brother MFC-7340 User Manual page 117

Error Message
Fuser Error
Init Unable XX
(XX = Enter Code)
Jam Rear
Jam Inside
Jam Tray
No Paper
Cause
The temperature of fuser unit
does not rise at a specified
temperature within specified time.
The fuser unit is too hot.
The machine has a mechanical
problem.
The paper is jammed in the back
of the machine.
The paper is jammed inside the
machine.
The paper is jammed in the paper
tray of the machine.
The machine is out of paper or
paper is not properly loaded in the
paper tray.
Troubleshooting and routine maintenance
Action
(MFC-7340 only)
Received fax messages still in memory will
be lost when the machine is turned off.
See Transferring your faxes or Fax
Journal report on page 110 before
disconnecting the machine so you will
not lose any important messages.
Then, turn the power switch off, wait a
few seconds, and then turn it on again.
Leave the machine for 15 minutes with
the power on.
(MFC-7450 and MFC-7840N only)
Turn the power switch off, wait a few
seconds, and then turn it on again. Leave
the machine for 15 minutes with the
power on. The machine can be turned off
for up to 4 days without losing faxes
stored in the memory. (See Transferring
your faxes or Fax Journal report
on page 110.)
Do one of the following:
(MFC-7340 only)
See Transferring your faxes or Fax
Journal report on page 110 before
disconnecting the machine so you will
not lose any important messages.
Then, disconnect the machine from the
power for several minutes and then
reconnect it.
(MFC-7450 and MFC-7840N only)
Disconnect the machine from the power
for several minutes, then reconnect it.
(The machine can be turned off for up to
4 days without losing faxes stored in the
memory. See Transferring your faxes or
Fax Journal report on page 110.)
(See Paper jams on page 112.)
(See Paper jams on page 112.)
(See Paper jams on page 112.)
Do one of the following:
Refill the paper in the paper tray, and
then press Start.
Remove the paper and load it again, and
then press Start.
B
107