Factory Default Settings; Web Interface (Username And Password); Lan Device Ip Settings; Isp Setting In Wan Site - Billion BiPAC 7404V series User Manual

Factory Default Settings

Before configuring your, you need to know the following default settings.

Web Interface (Username and Password)

Username: admin
Password: admin
The default username and password are "admin" and "admin" respectively.
If you ever forget the password to log in, you may press the RESET button up to 6
seconds to restore the factory default settings.
Attention
Attention

LAN Device IP Settings

IP Address: 192.168.1.254
Subnet Mask: 255.255.255.0

ISP setting in WAN site

PPPoE

DHCP server

DHCP server is enabled.
Start IP Address: 192.168.1.100
IP pool counts: 100

LAN and WAN Port Addresses

The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown below.
IP address
Subnet Mask
DHCP server function
IP addresses for
distribution to PCs

Information from your ISP

Before configuring this device, you have to check with your ISP (Internet Service Provider) what kind of
service is provided such as PPPoE, PPPoA, RFC1483, or IPoA.
Chapter 3: Basic Installation
LAN Port
192.168.1.254
255.255.255.0
Enabled
100 IP addresses continuing from
192.168.1.100 through 192.168.1.199
VoIP/(802.11g) ADSL2+ (VPN) Firewall Router
The PPPoE function is enabled
to automatically get the WAN
port configuration from the ISP,
but you have to set the
username and password first.
WAN Port
16