Billion BiPAC 7404V series User Manual page 50

the IP address manually. The setting of this item is specified by your ISP.
Authentication Protocol: Default is Chap(Auto). Your ISP will advise you whether to use Chap or
Pap.
Connection:
Always on: If you want the router to establish a PPPoE session when starting up and to
automatically re-establish the PPPoE session when disconnected by the ISP.
Connect to Demand: If you want to establish a PPPoE session only when there is a packet
requesting access to the Internet (i.e. when a program on your computer attempts to access the
Internet).
Idle Timeout: Auto-disconnect the broadband firewall gateway when there is no activity on the line
for a predetermined period of time.
Detail: You can define the destination port and packet type (TCP/UDP) without checking by
timer. It allows you to set which outgoing traffic will not trigger and reset the idle timer.
RIP: RIP v1, RIP v2, and RIP v2 Multicast. Check to enable RIP function.
MTU: Maximum Transmission Unit. The size of the largest datagram (excluding media-specific
headers) that IP will attempt to send through the interface.
TCP MSS Clamp: It is enabled by default. All TCP traffic routed through the interface will be
examined. If a TCP SYN (synchronize/start) segment is sent with a maximum segment size larger
than the interface MTU (Maximum Transmission Unit), the MSS option will be rewritten in order to
allow TCP traffic to pass through the interface without requiring fragmentation.
MAC Address Spoofing: Some ISP (Internet Access Provider) validates the ADSL connection by
checking the MAC address of given router or your PC Ethernet adapter. If you replace a new router
or PC or PC Ethernet adapter, your ISP may drop the ADSL connection because of false MAC
address. You can spoof the MAC address in order to get the ADSL connection.
Advanced Options (PPPoE)
LLC Header: Selects encapsulation mode, true for using LLC or false for using VC-Mux.
Create Route: This setting specifies whether a route is added to the system after IPCP (Internet
Protocol Control Protocol) negotiation is completed. If set to enabled, a route will be created which
directs packets to the remote end of the PPP link.
Specific Route: Specifies whether the route created when a PPP link comes up is a specific or
default route. If set to enabled, the route created will only apply to packets for the subnet at the
remote end of the PPP link. The address of this subnet is obtained during IPCP negotiation.
Subnet Mask: sets the subnet mask used for the local IP interface connected to the PPP transport.
If the value 0.0.0.0 is supplied, the netmask will be calculated from the class of the IP address
obtained during IPCP negotiation.
Route Mask: Sets the subnet mask used by the route that is created when a PPP link comes up. If
it is set to 0.0.0.0, the subnet mask is determined by the IP address of the remote end of the link.
The class of the IP address is obtained during IPCP (Internet Protocol Control Protocol) negotiation.
MRU: Maximum Receive Unit. This is negotiated during the LCP protocol stage.
Chapter 4:Configuration
VoIP/(802.11g) ADSL2+ (VPN) Firewall Router
49