Billion BiPAC 7404V series User Manual page 159

Bridge Interface
Ethernet
Ethernet1
Ethernet2
Ethernet3
Step 2: Create WAN Interface
Go to Configuration
wanlink is the factory default WAN interface which in service for data/internet access. If your ISP
uses this access protocol, click Edit to input other parameters if needed. If your ISP does not use
PPPoE, you can change the default WAN connection entry by clicking Change.
From the example, 0/40 is used for data/internet and assumes PPPoE is used; click the Edit to
change the VPI/VCI to 0/40.
Click Create to setup up additional WAN interface for video applications. Total of 8 VLAN is support;
therefore, only 8 WAN interfaces can be created in the table.
From the example, PVC 0/33 to 0/39 is assigned for video using 1483 Bridged mode. Check RFC
1483 Bridged and click Next to continue the setup.
Spaces next to VPI and VCI, type 0 and 33 in respectively. Select appropriate ATM Class,
Encapsulation Method, Acceptable Frame Type, Filter Type and PVID for Untagged Frames.
Chapter 4: Configuration
WAN ISP
VoIP/(802.11g) ADSL2+ (VPN) Firewall Router
VLAN Port (Always starts with)
P1 / P2 / P3 / P4
P2 / P3 / P4
P3 / P4
P4
158