Baumatic BHI631SS Instruction Manual page 22

o The heat produced by the oven, measured on the right side of
the bottom of the hob, must be lower than 60°C, otherwise the
heat could damage the touch control panel.
o IMPORTANT: You must observe the ventilation requirements
shown in the drawing below.
o Carefully turn the hob upside down and place it on a cushioned
mat.
o Apply the sealing strip provided (A) around the edge of the
appliance.
o The protective covering must be removed from both sides.
o Do not leave a gap in the sealing agent or overlap the thickness.
o IMPORTANT: Do not use a silicon sealant to seal the appliance
against the aperture. This will make it difficult to remove the hob
from the aperture in future if it needs to be serviced.
22