HP ProLiant DL160 Generation 6 Specification page 34

QuickSpecs
Memory
3 DIMM Per Channel
NOTE: * Supported with ROM update via ROM Based Setup Utility (RBSU). UDIMM support is on12-slot server.
NOTES:
Mixing DIMM speeds is allowed, but the system processor speed rules always override the DIMM capabilities
If you do mix DIMM speeds, the memory bus will default to the minimum clock rate of all DIMMs in the system - even if the
slower DIMM is on the other processor
If you install 1x 1066MHz DIMM in channel 1 and 1x 1333MHz DIMM in channel 2, you still run at 1066MHz
If you install 1x 1066MHz DIMM in channel 1 and 5x 1333MHz DIMMs with 1 DIMM Per Channel (DPC) in each of the
other channels, you run at 1066MHz
If you install 3DPC in one channel (if applicable) and 1DPC in all other channels, you run at 800MHz
95 Watt CPU's are required for 1333MHz DIMM speeds. All other CPU's are capable of up to 1066MHz
References to the above MHz speeds are for the various speeds of DDR3 DIMMs; 1333 refers to DDR3-1333, etc.
DIMM slot and configuration diagrams
Basic memory slot & population diagram
Population order; start with "A" first, "B" second, "C" third, etc.
Chnl 1
Chnl 2
Chnl 3
Standard memory configuration (1 CPU model)
6GB, consisting of three (3) 2GB dual-rank PC3-10600 RDIMMs
800 800
18 DIMM SLOTS (9 per CPU node)
CPU1
slot # population order
1 G
2 D
3 A
4 H
5 E
6 B
7 I
8 F
9 C
DA - 13247 Worldwide QuickSpecs — Version 11 — 11.16.2009
HP ProLiant DL160 Generation 6
not
800 800
supported
CPU2
slot #
1
2
3
4
5
6
7
8
9
not not
supported supported
population order
G Chnl 1
D
A
H Chnl 2
E
B
I Chnl 3
F
C
not
supported
Page 34