Barco BlendPRO-II User Manual page 27

Please continue with system setup, menu orientation and operations, as outlined in
Chapter 4, "Operation" on page 29.
pÅêÉÉåmolJff=dÉåäçÅâ=qÉêãáå~íáçå
On the rear of each ScreenPRO-II chassis, one recessed Termination Switch is provided
for genlock termination (adjacent to the Genlock Loop connector).
•
•
If a particular ScreenPRO-II chassis is the last device in a reference video chain, ensure
that the Termination Switch is pushed in. If a particular ScreenPRO-II chassis is in the
middle of a reference chain, ensure that the Termination Switch is out.
BlendPRO-II • User's Guide
c. (If your system includes three ScreenPRO-IIs) — Connect the second
ScreenPRO-II's GENLOCK LOOP connector to the GENLOCK IN
connector on the ScreenPRO-II with the next highest numbered ID.
d. (If your system includes four ScreenPRO-IIs) — Connect the third
ScreenPRO-II's GENLOCK LOOP connector to the GENLOCK IN
connector on the ScreenPRO-II unit with the highest numbered ID.
e. Set the Termination Switch for all ScreenPRO-IIs in your system:
• For all ScreenPRO-IIs except the last one in the chain, ensure
that the ScreenPRO-II is un-terminated (HI-Z). Refer to the
"ScreenPRO-II Genlock
details.
• On the last unit in the chain (only), ensure that the
ScreenPRO-II is terminated (75-OHM).
Terminated — when the switch is pushed in, the connection is terminated (75
Ohms).
Un-terminated — when the switch is out, the connection is un-terminated.
3. Installation
Signal Installation
Termination" section on page 27 for
27